Art Decor I-04-5092-CH Przewodnik Instalacji

Przeglądaj online lub pobierz Przewodnik Instalacji dla Akcesoria do montażu na ścianie i suficie Art Decor I-04-5092-CH. Art Decor I-04-5092-CH Installation Guide Instrukcja obsługi

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 3
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 0
TEKNO 25 INSTALLATION
INSTRUCTIONS
STEP 1 - Installing Supports
Height calculation for regular clips.
Add 1” to length of drapes, plus at least 1/2” clearence from
the fl oor. This measurement is the distance from fl oor to center
point of Back Plate.
Please note drapes should not touch rail,
install pin on hooks with this in consideration.
M-6 BOLT COVER PLATE INSIDE POST
1. Install Back Plate to wall. Make sure all M-6 bolts are level.
If you have a spliced track the Center Support must be
installed at the position of splice.
2. Cover Back Plate with Cover Plate.
3. Screw on Inside Post very securely. Do not leave any play.
STEP 2 - Splice track if necessary
CENTER
SUPPORT
SET SCREWS
SPLICE
STEP 3 - Installing Outside Posts
1. Join the track sections
together.
2. Tighten set screws.
3. Screw Center Support
directly into center hole
of Splice.
1. Loosen all screws on Outside Posts.
2. Slide Ouside Posts into back channel of Rail.
3. Align Outside Posts with Inside Posts from Step 1.
OUTSIDE POST
1
2 3
4
5
1. Slide Outside Posts over
Inside Posts.
2. Once all Outside Posts
including Center Supports
are in place, tighten
posts securely by turning
clockwise.
3. Tighten set screws.
4. Finished result for
Center Supports.
5. Finished result for
side posts.
STEP 4 - Mount rail onto supports
OUTSIDE POST
CARRIERS
COVER PLATE
INSIDE POST
BACK PLATE
Przeglądanie stron 0
1 2 3

Podsumowanie treści

Strona 1 - INSTRUCTIONS

TEKNO 25 INSTALLATIONINSTRUCTIONS STEP 1 - Installing SupportsHeight calculation for regular clips.Add 1” to length of drapes, plus at least 1/2” clea

Strona 2 - STEP 6

STEP 7 - Cord Draw Systems, Installing Pulley1. Attach pulley to cord. Stretch pulley until cord is tight. It is not necessary to use excessive tens

Strona 3 - STEP 5 - Installing Pulley

STEP 1 - Assembling track when splicer is includedSTEP 2 - Installing mounting hardware1. Assemble Upgrade Clips for Outside Posts.2. Attach assembl

Komentarze do niniejszej Instrukcji

Brak uwag